Codeway Checkrite barcode checking system
Inspect barcodes on the line
Customers sometimes levy hefty fines for bad barcodes. CheckRite makes sure the correct barcode is on every pack coming off your line. It raises the alarm - and can stop the line - when a barcode is missing, unreadable or wrong. CheckRite is easy to install and use. Mount the scanner over the line, set up the control unit, scan a master barcode and away you go. You can connect CheckRite to your computer to log production, and concentrate data from several lines in a daisy chain.
SPECIFICATION |
|
| Indicators LED | FAIL no read or no match |
| GOOD good read | |
| NEW new master signal | |
| POWER power on | |
| TRIG scanner trigger signal | |
| Controls | FAIL acknowledge fail state and cancel alarm |
| NEW set new master barcode | |
| RESET key switch | |
| TRIG trigger scanner | |
| Audible Alarm | Fast pulse 2.9 Khz, 90 dB at 600mm |
| Interface | FAIL output |
| GOOD READ output | |
| Serial Data | RS232 single CheckRite on one line |
| RS485 multiple CheckRites on several lines Requires Microscan MS 5000 concentrator | |
| Scanner options | Microscan MS 810 linear laser Use for scanning across conveyor - ie with bars of barcode parallel to direction of conveyor. |
| Microscan MS 850 raster laser Use for scanning along conveyor - ie with bars of barcode at 90° to direction of conveyor. | |
| Power | Voltage: 85 - 264 VAC |
| Frequency: 47 - 63 Hz | |
| Consumption: 25W | |
| Mains inlet: 3 pin IEC; fuse: 500mA T HRC | |
| Environmental | Operating temperature: 0° - 50°C ambient |
| Relative humidity: 85% max non-condensing | |
| Mechanical | Width: 200 mm |
| Height: 300 mm | |
| Depth: 130 mm excluding mountings | |
| Weight: 4.1 Kg excluding mountings |
 |
MICROSCAN MS 810 Single line industrial scanner
300 - 800 scans / second 5 mm - 750 mm read range |
 |
MICROSCAN MS 850 Raster scanner for reading barcodes in various positions
350 - 1100 scans / second 5 mm - 750 mm read range |
bar code verifiers and checkers